Tools

Credit utilization calculator

Divide balance by limit for each card and for all of them together, then see the payment that brings each ratio down to a target you set.

Runs entirely in your browser: nothing you enter is sent or stored by this site. Results are estimates for planning, not a quote or advice.

Utilization is the share of your credit limits that your balances use. This tool works it out for each card and for all your cards together, and it shows how much you would have to pay to reach a target ratio you choose.

How to use it

Type a balance and a credit limit for each card, up to six. Names are optional. A blank balance counts as $0, and a row with both boxes empty is skipped. Then set the target utilization. The figures in the boxes when the page loads are an example, so replace them with yours.

The results update as you type. You get the overall ratio, the highest single card, the payment needed to bring the overall ratio to the target, and the payment needed to bring every card to the target. A table below lists each card with a plain-text note on whether it is at or above the target.

How the math works

Utilization = balance / limit, worked out per card and again with all balances over all limits.

  • Card ratio = card balance / card limit.
  • Overall ratio = sum of balances / sum of limits.
  • Payment to reach target ratio T on one card = balance minus T times the limit, or $0 if that is negative.
  • Payment to bring the overall ratio to T = total balance minus T times the total limit, or $0 if negative.
  • Payment to bring every card to T = the sum of each card's own payment.

The last two differ because paying one card down does nothing for another card's own ratio.

Worked example (the default boxes). Card A has $1,800 on a $6,000 limit, Card B $450 on $3,000, and Card C $0 on $5,000. Balances total $2,250 and limits total $14,000, so overall utilization is 2,250 / 14,000 = 16.1%. Card A is the highest at 1,800 / 6,000 = 30.0%. Set the target to 10%. The overall payment is 2,250 minus 0.10 times 14,000, which is $850. To bring every card to 10%, Card A needs 1,800 minus 600 = $1,200, Card B needs 450 minus 300 = $150, and Card C needs nothing, a total of $1,350.

What it assumes

  • Balances are the numbers you typed. A scoring model reads the balance your issuer reports to the credit bureaus, often the statement balance, which can differ from today's balance.
  • The target is your own. FICO does not publish a cutoff, and a figure of about 30% is a commonly quoted rule of thumb rather than a rule.
  • Every card has a stated limit. Cards without a preset limit are left out.
  • Amounts are rounded to cents in the table and percentages are shown to one decimal.

Where it stops being right

The tool cannot know which balance your issuer reports, or on what day. Paying before the statement closes changes the reported figure and paying after it does not, and this tool does not model that. It also cannot see how a specific scoring model treats a single card with a high ratio against a low overall ratio, so the highest-card line is information, not a prediction. Closed cards, authorized-user accounts and cards that stop reporting limits can change the picture in your actual credit report. Nothing here predicts a score.

Last reviewed November 16, 2026

Terms used here

Latest on this topic